GLTX Single Button Fixed Code Remote

• Fixed code technology

•  For Rhino LS & GA Car Alarms

Code: GLTX

• Yellow LED
• Suits Rhino RCX & RES immobilisers, WGUARDSMS & WGUARDMARINE

• Red LED
• For Rhino GTS Car Alarm

Code: GTSTX

Programmable 4 Button Replacement Remote
Code: PTX

The Rhino PTX Remote Control can duplicate a majority of fixed code remote controls (not code hopping remotes). Fixed code means that each time the remote control is pressed, the same code is transmitted each time. The PTX remote has four buttons so that it will universally suit most remotes i.e. some remotes have just one button for arming / disarming, where others may have separate buttons for multiple functions. The same code can be copied onto multiple buttons if desired. If your original remote has a function controlled by pressing multiple buttons together, you must duplicate that code to a single button on your Rhino PTX.

 

• 4 channel programmable remote control
• Many uses including car alarms, home alarms, panic buttons, garage doors
• Copies most radio frequency fixed code remote controls
• Learns in seconds
• 255-500 MHz adjustable frequency
• Battery included

• As supplied with Rhino RXPROR4. Optional use with Rhino RCX, RES, JAG, RAM, WGUARDSMS & WGUARDMARINE
• Colour coded buttons with printed numbers to match GTTX / RCTX3-T i.e button 1 on Your RCTX4-U is the same function as button 1 on your GTTX remote

• 3 button remote With LED torch
• As supplied With Rhino JAG, RA & RAM Car Alarm
• Also compatible with Rhino RCX, RES, WGUARDSMS & WGUARDMARINE

This tool is ideal for both home and vehicle technicians to quickly check if UHF remotes are working and re-tune to correct frequency if required.

 

• Large easy to read display
• Reads 250 ~ 500 MHz
• Power supply included

The RXPROR4 is an advanced multi-purpose 4-channel narrow-band UHF receiver / transmitter set with fully programmable relay outputs (1 amp rating). It is supplied as standard with 2 x code hopping, 4 button remote controls with long life lithium batteries. It can be used to add Watchguard wireless alarm accessories to virtually any alarm panel or device.

The RXPROR4 can add 4 Channel wireless control to any device, on - off , open - close,
 

• Up to 200m radio frequency range (line of sight)
• All outputs are individually programmable to suit almost any application (momentary, latched, timed or pulsed)
• Up to 5 high security code hopping remotes (anti-scan, anti-code grabbing) can be used
• Power supply requirement: 12VDC @ 500mA
• Compatible with Watchguard wireless alarm detectors
• Up to 4 wireless detectors can be used
• Supports detector low battery, supervision & tamper signal outputs
• Step by step programming via remote control & indication via feature and channel LED's 

More Info on RXPROR4 Press Here